Thingiverse
Delonghi Knob Replacement
por amclean
1
Descargas
0
Likes
0
Makes
The knob on my De'Longhi ECP3420 broke during disassembly, so I designed a replacement. This should fit other similar models.
I recommend printing this in ABS, as the heat will cause PLA to warp. Print with supports toughing build plate. Had good results with 0.1 mm layer height, as well as 0.2 mm layer height. Infill density isn't super important, just make sure to print with a decent amount of walls (I chose 4).
I print it in the orientation that the model is currently in.
I recommend printing this in ABS, as the heat will cause PLA to warp. Print with supports toughing build plate. Had good results with 0.1 mm layer height, as well as 0.2 mm layer height. Infill density isn't super important, just make sure to print with a decent amount of walls (I chose 4).
I print it in the orientation that the model is currently in.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
