Thingiverse
Delta 5 Lap Timer/Race Timer (D5RT) - case for V2 PCB
von lmig
18
Downloads
8
Likes
1
Makes
Case for the Delta 5 lap timer case V2 PCB & Raspberry Pi 3, designed to be compact and accessible.
The case is 110x110x48mm small. It incorperates the official V2 PCB for up to 4 nodes, a 40x40x10 cooling fan, a voltage display from Banggood and a Raspberry Pi 3B.
No need for extra hardware/screws. The bottom and top pieces snap fit together, the PCB and Raspberry Pi as well.
The Arduino USB Port and the Raspberry Pi Ethernet and 2 USB Ports are accessable from outside.
2 cases can be stacked together to extend the lap timer to a 8 node system, using a bracket, and some Arduino connection cables, if necessary.
If 4 nodes are found channels R1, R3, R5, R7 are beeing assigned and on 8 node Raceband 1-8 (configureable in the server.py script). For LiveTime use the Arduino frequency set in the arduino code is beeing retrieved.
The holder for the fan in the top pieces is for a press fit installation, if the fan has grooves on the side, like mine have. If they don't you ca
The case is 110x110x48mm small. It incorperates the official V2 PCB for up to 4 nodes, a 40x40x10 cooling fan, a voltage display from Banggood and a Raspberry Pi 3B.
No need for extra hardware/screws. The bottom and top pieces snap fit together, the PCB and Raspberry Pi as well.
The Arduino USB Port and the Raspberry Pi Ethernet and 2 USB Ports are accessable from outside.
2 cases can be stacked together to extend the lap timer to a 8 node system, using a bracket, and some Arduino connection cables, if necessary.
If 4 nodes are found channels R1, R3, R5, R7 are beeing assigned and on 8 node Raceband 1-8 (configureable in the server.py script). For LiveTime use the Arduino frequency set in the arduino code is beeing retrieved.
The holder for the fan in the top pieces is for a press fit installation, if the fan has grooves on the side, like mine have. If they don't you ca
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
