Delta Case - Reviung41

The Delta Case is my take on a 3D printed gasket-ish mount case for the Reviung41 (designed by gtips) based on the original case files on github. Information about the keyboard, pcb, and plate files can be found here: https://github.com/gtips/reviung/tree/master/reviung41

Note: While the case is 3D printed, the top plate is not. This design requires the standard top plate per the files on github, as well as the standard spec M2 standoffs. Case height offset can be adjusted with different length standoffs or by scaling the thickness of the gaskets. Different length screws may be required.

I am marking this project as WIP because I may revisit to design a different top plate and fill in any gaps. I like a uniform top, this was made to accommodate my existing plate.

Delta Case BOM:
- 1x Case Full (or 1x each Case Right and Case Left)
- 2x Gasket Outer
- 1x Gasket Inner
- 1x Delta Badge
- 1x MCU Cover (with or without encoder hole)
- 1x Top Plate Holes Cover (not required,