Delta Effector Light Strip Fixture

I don't know if this will work for other configurations because I didn't find many designs for my config: FLSUN Delta with the effector on the 'positive' side of the carriage.

Designed to illuminate the filament out of the nozzle while not blocking view, also not crash into anything for any range of motion (enclosure, proud bed SHCS's, belts, rod ends, etc).
Oh, and I wanted to use the LED strips I already have.

http://a.co/j1npHO0

they are dirt cheap, 2" per division and this design uses 4" total.

I tapped into the 'always on' fan and did an ugly JST connector splice, but it is removable now.

I only print in ABS so I removed cooling fan and duct.


Also included a pic of the original design that was 6" with more LEDs but covered the majority of the viewing angles. I stress tested by heating nozzle and bed and leaving it on all day... 3 out of 9 LED's had died. My power supply was set at 12.5 Volts which overdrives them, but also that config captured too much heat.