µDelta LCD holder

This is a dead-simple LCD holder for the eMotion-Tech µDelta printer. You should print two of twose and attach them to the LCD using M3x12 (or shorter) screws and nuts, and a pair of 4x12 wood screw (or similar size) to attach to the top plate of the printer.

The LCD connector will be just below the top plate, and you should leave the space between the top plate and the screen to pass the cable.

This holder is inspired by the one provided by eMotion-Tech, but it does not require assembly so it's easier to use.

It prints fine in PLA, using a 0.2mm layer height.