Delta Mines 3D Printer

Solidworks model and approximate Bill of Materials of a Delta Arm 3D Printer. Assembly size is ~100MB so open in large assembly mode! Based on Werner Berry's BerryBot 3D. Here is Werner Berry's YouTube Channel: http://www.youtube.com/channel/UChZIa-t7aKDU2TE7tAuY3IA

Solidworks note: There are 3 mates inside the carriage folder securing the 3 carriages. suppress those 3 mates in the folder and you can move the hot end platform around.


Named "Delta Mines" for the university it was used at.

**Print size**: 16'' diameter x 17'' tall.
**Estimated cost from scratch**: ~$2,500 (Including wire, switches, etc...)

**Features**:
4 nozzle hot end (bowden setup) Water cooled using condensate pump and radiator. heater cartridges are 100vac at 100 watts from McMaster.
nozzle assemblys are secured loosly with a shaft colllar with a plastic insert betweein the tube and set screw to prevent head crashing.
aluminum construction (Aluminum panels and 20mmx20mm aluminum extrusi