Thingiverse
Demogorgon Remix
por Plasticfeegle
271
Descargas
128
Likes
0
Makes
Scaled Demogorgon up to match the miniatures that I use (1 ft = 6.6667 mm) and found he was too big to print. Dropped it into Tinkercad to remove the arms and orient them for printing. I then decided that the "Prince of Demons" needed a base befitting his status. Assembled with Aleen's Premium Quality Orignal Tacky Glue. One arm required a latex free elastic to hold it in place while it dried. Two of his ears broke off and disappeared (with the help of a cat). They have been replaced with pieces of raft. Note with the base, I tried printing it multiple times. It turned out better when printed upright. With arm 2, snip the tip of the tentacle off the raft before trying to remove it.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
