MakerWorld
Hueforge & Lithophane
Zum Modell
Demon Dogs
11
Downloads
12
Likes
11
Makes
Project: Demon DogsPrint at 100% infill with a layer height of 0.08mm with a base layer of 0.16mmThe Model is 200x200mm in sizeYou may print at higher layer heights below the Min Depth of 0.64mmThe Max Depth is 2.2mm and the Actual Depth is 2.3mm This print uses 4 unique filamentsPLA BambuLab Basic Black PLA BambuLab Basic Red PLA BambuLab Basic Yellow PLA BambuLab Matte Ivory White Swap Instructions:Start with BlackAt 0.8mm swap to RedAt 1.2mm swap to YellowAt 1.68mm swap to Ivory White for the rest.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
