Demon on his Throne

This highly detailed Demon King seated on an ornate throne is designed as a display-quality fantasy model featuring intricate armor, horns, wings, skulls, spikes, and a detailed trident. The model contains numerous overhangs, suspended elements, and fine decorative details that require careful support placement to achieve a successful print. Recommended Print Settings Material: Silk Red PLA Layer Height: 0.12–0.16 mm Wall Count: 3–4 walls Infill: 10–15% Gyroid Print Speed: 40–60 mm/s Nozzle: 0.4 mm Supports: TREE SUPPORTS REQUIRED Build Plate Adhesion: Brim recommended IMPORTANT SUPPORT REQUIREMENTS ⚠️ TREE SUPPORTS MUST BE ENABLED FOR THIS MODEL. Due to the extreme amount of overhangs and intricate geometry, standard supports may damage fine details and be difficult to remove. Tree supports are strongly recommended and should be considered mandatory for a successful print. Tree supports should be used to support: Horns Wings Throne spikes Armored overhangs Hands and fingers Trident Under-throne details Hanging ornaments and skulls Any overhang exceeding 45° Orientation Print the model upright in its throne position as designed. Do not lay the model flat, as this will significantly reduce detail quality and increase cleanup work. Expected Results When printed in Silk Red PLA, the model produces a dramatic metallic appearance that highlights the intricate sculpting and armor details. Tree supports allow the fine features to remain intact while minimizing support scars and post-processing work. Failure to use tree supports will likely result in failed overhangs, damaged details, and poor print quality. Tree supports are strongly recommended for the entire model.