Slicer Discord
Deodorant Stand – Modèle 3D imprimable de Thingiverse Thingiverse

Deodorant Stand

par sandbk
22 Téléchargements
15 Likes
0 Makes
Voir le modèle
This stand stops my deodorant stick from falling over and making a mess of the medicine cabinet.

I find that stick deodorants are always falling over. To make matters worse, the deodorant stick gets increasingly unstable as you use it since the center of gravity moves further and further up; so it falls over more and more. Enough! This stand will finally give your deodorant stick a stable home.

One of the principles of 5S is "seiton" or, roughly, "set in order." This stand makes a place for your stick deodorant.

This stand was made for an Old Spice stick, but will accommodate a stick deodorant of elliptical cross-section that is less than 2.68" wide by 1.35" thick. I printed it at 50% infill to give it mass. If you'll tape it in place, I'd print it at 20% infill.
Source
Thingiverse
Ce qu'il faut pour imprimer: Débutant Confiance faible
Monobloc
Supports 1/3
Assemblage 0/3
Réglages 1/3
Taille du plateau 0/3
Post-traitement 0/3
Imprimante
FDM / FFF
Format de fichier
STL
Matériau
PLA
Logiciel
Cura, PrusaSlicer ou similaire
Pas encore d'évaluations
Pas encore de commentaires – soyez le premier !

Modèles similaires

6 Suggestions
Feed Blog Slicer Calculateur Recherche par image Soumettre Contact Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Ajouter à la collection