Derpy Labrador Head

I set out to print two large versions of this to use as entryway decorations so the filament choice was Amolen's Dark Wood Fiber PLA. Weatherproofs nicely after a few coats of clear sealant.

You should rotate the model 90 degrees back in your slicing software so it prints on the largest flat surface. I used PrusaSlicer's Paint On Supports to minimize the amount of supports needed under the ears. I haven't test-printed the auto-generated supported model but I don't see why anyone would have any issues doing so themselves if you're unfamiliar with setting custom supports.

If you'd like to learn more here's a video from Prusa on Paint On Supports.
https://www.youtube.com/watch?v=6LLK9soDW88