Thingiverse
deserteagle Trigger guard holster
von dai20222
1
Downloads
2
Likes
0
Makes
This is a trigger guard holster for the Desert Eagle.
I made it because it didn't exist.
It fits the Tokyo Marui Desert Eagle.
The recessed nut hole is compatible with Blackhawk.
I also made one for the left hand. Please use it if you like.
M5Nut 3
M3bolt 30-35mm 1
spring This spring was purchased locally. Its outer diameter is about 7mm and its length is about 25mm.
I made it because it didn't exist.
It fits the Tokyo Marui Desert Eagle.
The recessed nut hole is compatible with Blackhawk.
I also made one for the left hand. Please use it if you like.
M5Nut 3
M3bolt 30-35mm 1
spring This spring was purchased locally. Its outer diameter is about 7mm and its length is about 25mm.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
