Slicer Discord
Desiccant box with latching lid – 3D-Druckmodell von MakerWorld MakerWorld
3D Printer Accessories

Desiccant box with latching lid

427 Downloads
83 Likes
135 Makes
Zum Modell
This is a pretty simple desiccant box that fits a few specific design criteria that I had, which I didn't seem to find elsewhere. Hold a decent amount of desiccantDon't have the desiccant be too deep (otherwise the air won't really penetrate to the center)Have a lid that will stay on even when the box tumbles around a bitLots of holes for airflowNo screws or other extra hardware requiredFit in my dehydrator to dry the desiccant without removing it from the boxHold up to shaking the box a bit without the lid coming off to stir up the desiccant while dryingLook good (subjective, I know)I recommend using ASA to make drying the filament without removing it from the box easier, but PETG would likely work as well. Because the lid needs to flex a little to put it on/off, and it's low temperature handling, I do not recommend using PLA All of the holes are modeled in, no slicer tricks using infill patterns with no top/bottom layers. This was done so that the holes on the top/bot
Kategorie
3D Printer Accessories
Quelle
MakerWorld
Veröffentlicht
Aktualisiert
Was du zum Drucken brauchst: Mittel Niedrige Konfidenz
Einteilig Hardware nötig
Supports 1/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 1/3
Drucker
FDM / FFF
Dateiformat
STL
Material
PLA, PETG, ASA
Nachbearbeitung
Hardware
Software
Cura, PrusaSlicer o. Ä.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!

Ähnliche Modelle

6 Vorschläge
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen