Desiccant Container - Vase Mode

I've wanted to design a vase mode printed part that is actually functional and not just decorative for a long time and this seemed like the perfect project to do it on.

I wanted a container for desiccant that didn't have all those spindly little parts that are so annoying to print so I decided to make one that would be much easier and faster to print using vase mode. I also wanted it to have a lid that would just snap together so I didn't have to worry about clips or latches, and so after a couple iterations I came up with this.

It was also designed to fit in the center of most spools to save a little space. It should fit any desiccant beads that are 2 mm or larger without leaking, though you will get broken pieces that fall out of the sides and top at first.

Here's the desiccant I use but you might want to go up a size because the little broken bits like to fall out a lot:
https://www.amazon.com/gp/product/B019NN1GBG/

If you print it out of ABS or PETG you should theore