Designer Desk Lamp

This designer desk lamp is great for for a small work desk. You can use PETG or translucent PLA for brighter diffuser, but normal PLA will work as well since the walls are only 1.5mm thick. Roughly about 8inches high and 6inches wide   Keep in mind you will need the ANYCUBIC LED KIT for this project. https://store.anycubic.com/products/led-lamp-creative-kit   Directions: Using the ANYCUBIC Light Kit run the USB cord in the middle of the LIGHT MOUNT. Once through the circle of the LIGHT MOUNT, continue to the BOTTOM of the vase portion and out the back of the square hole on the bottom > Pull the wire and light switch all the way through the BOTTOM BASE. The LIGHT MOUNT will slide on top of the BOTTOM BASE. SNAP in the PLUG CAP to pretty up the wire Connect the DIFFUSSER by laying it on the LIGHT MOUNT ( super glue can be used to make to permanent)