MakerWorld
Organizers
Go to Model
Desk Cable Management Holder
348
Downloads
61
Likes
145
Makes
A desk cable organizer that orients the cables 90 degrees. Which IMO is easier to access than straight up and cleaner looking diagonal.Pre-made models desk thicknesses:1.5in, 1 3/8in, 1in, 17mm Printing:No supports. Stay away from 100% infill as the part needs to flex a bit to friction fit onto your desk. Other than that, you can print it however you like. Filament:Any filament works, but PETG and TPU are slightly better since its more flexible. PLA is still fine. Boost MeSimple, cheap and fast to print models. If that sounds good to you then a boost sounds good to me!
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
