Thingiverse
Desk grips for wire spool support.
von Richy_T
1
Downloads
1
Likes
0
Makes
Designed to allow a wire support for my spool of ABS. Not sure how it will turn out. Desk thickness is 1 1/8" (approximately 29mm)
Update: As a foray into openscad, this wasn't bad but unfortunately, these were simply not strong enough for the job. I'm going to abandon them and seek other options.
Update: As a foray into openscad, this wasn't bad but unfortunately, these were simply not strong enough for the job. I'm going to abandon them and seek other options.
Richy_T veröffentlicht auch auf
15 zusätzliche Modelle auf 1 weiteren Plattformen
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!