Thingiverse
Desk Headset Holder
door EngineeringWithLui
2
Downloads
1
Likes
0
Makes
A simple headset holder as I wanted to utilise some space off my desk and what better than a holder to hang over the edge!
I made this wayyyyy too thick, so I'd recommend to scale it down. Each "bar" is 5mm thick, on the plus side is it is solid AF but it also took 4.5hours to print.
Make sure you print this flat i.e. rotate and drop it down in your slicing software.
I measured this to fit exactly an IKEA desk with the desk-top thickness of 16.6mm.
I made this wayyyyy too thick, so I'd recommend to scale it down. Each "bar" is 5mm thick, on the plus side is it is solid AF but it also took 4.5hours to print.
Make sure you print this flat i.e. rotate and drop it down in your slicing software.
I measured this to fit exactly an IKEA desk with the desk-top thickness of 16.6mm.
EngineeringWithLui publiceert ook op
20 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
