Desk Lamp Bracket

I needed a clamp to hold 2 LED light poles on my standing desk so the lights would raise and lower as the desk did. I found some inexpensive lights, removed the floor stand, and made two clamps to hold them to the desk. The clamp will work on a desk up to 35mm (1-3/8") in depth and a lamp pole up to 17.5mm (5/8") in diameter. It includes a bottom plate to prevent the holding screw from scratching the desk as you tighten it and a pole pressure plate to keep the light pole as upright as possible. There are two screws in the model. Each has small holes indented on the inside surface. The screw with 1 hole goes on the back of the clamp to hold the light pole in place. The screw with 2 holes goes on the bottom of the clamp to hold it to the desk. Printed with eSun PLA+, but any decent brand PLA should work.