Desk Lamp

Just a simple minimalistic desk lamp.
What you will need in addition to the printed parts:

2 x 20mm x 30cm wooden rods (you can vary the length)
1 x GU10 lamp holder
2m (or more) red sleeved cable
1x standard flick switch (19x13mm)
2 x M6 bolts (choose the head style you like)
2x M6 nuts
2x springs that fit around the bolts (TPU spacers might also work, did not try this though)
1x wallplug
about 600g of concrete
basic soldering skills

Printed parts:
1x base
1x CableClipBracket
1x standart bracket
2x "winkelbrackethole"**
1x "lampenschirm"

**this has a bigger hole to fit the screws I am using. It also allows a bit more movement.

Assembly should be pretty self explaining, start by pouring the concrete into the base so you can print the rest while it is curing. This project involves wiring that should be performed by trained professionals. I will not provide any further information on this because it should be done according to your country's safety standards.