Desk Organizer

Created this cause its similar to one i had bought made out of cardboard and i liked it. I also wanted it to be the same size cube as a 6U one of these drawer shelf units cause I have them on my desk https://www.thingiverse.com/thing:2302575

It has thick walls, heavy and takes a day to print.

V1 is straight from tinkercad and all the edges and corners are 90degree angles
V2 is my attempt in blender to slightly round most corners mostly to strengthen it. It is also 3mm higher than v1.

I printed v2 it came out fine and usable. There was some artifacts on the back of the middle 2 uprights. Not sure why because they don't show in either blender or cura. Could have been my printer bugging out.