Desk shelf legs

Table Shelf I built a simple yet sturdy table shelf.I used six of these printed legs — one in each corner and two in the back for extra support.For the shelves, I used wooden panels from my local hardware store:one panel: 120 × 30 cmone panel: 80 × 20 cmI assembled everything with screws, and I’ve been happily using this shelf for over six months now — it’s rock solid!I printed the legs in PETG with 100% infill, which in hindsight was overkill — you don’t really need that much infill for this application.Leg height: 15 cmBottom of the leg is designed to fit a rubber foot/pad.The gap between the top and bottom shelves is 7.5 cm (if you use 18 mm thick wooden panels).Hope this helps you make your own!