Thingiverse
Gadgets
Go to Model
Desk Speaker Stand
228
Downloads
205
Likes
2
Makes
A desktop stand for "5-inch" class monitors or bookshelf speakers.
Raises the speaker off the desk so it takes up less room, and angles it upwards at 15 degrees to better point at the listener. Suits speakers with a footprint about 6.5 inches square, which is a fairly standard size for speakers with a 5-inch main driver. The photos show it supporting a pair of Polk Audio R15's.
No special print settings required. I used AMZ3D grey PLA at 0.2mm layer height with 20% cubic infill.
Small self-adhesive felt or cork dots can be applied to the bottom and top surfaces to act as feet to prevent vibrations at high volumes and protect surfaces if desired.
Raises the speaker off the desk so it takes up less room, and angles it upwards at 15 degrees to better point at the listener. Suits speakers with a footprint about 6.5 inches square, which is a fairly standard size for speakers with a 5-inch main driver. The photos show it supporting a pair of Polk Audio R15's.
No special print settings required. I used AMZ3D grey PLA at 0.2mm layer height with 20% cubic infill.
Small self-adhesive felt or cork dots can be applied to the bottom and top surfaces to act as feet to prevent vibrations at high volumes and protect surfaces if desired.
mdkendall also publishes on
30 additional models across 2 more platforms
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
