Desktop Fountain (Pipe)

**I read and respond to every comment, so please share your questions, comments, and concerns.**

*Thanks to Vortex_pr for Part 3 of this fountain.*

***Update: The fountain failed overnight. It leaked and caused damage to my wood table that it was on. Download at your own risk.***


Print each part.
You will also need a water pump. I used the AM-118USB Submersible USB pump. It has a 2-foot water lift.



Attach Part 3 to the pump nozzle so that when the pipe is in normal position, the pump inlet is facing downwards. (With the suction inlet facing downward, less water is needed. Remember, if the water level drops below the pump inlet, air will get in and the pump will stall.)

Place this assembly into the base of Part 1, so that the pipe is approximately centered.

Place Part 2 over top of everything, with the square hole letting the pipe through and the water falling down through the hole.

Part 2 also has a notch to allow the pump wire to come through.