Desktop Microspeakers [HexiBase Remix]

I changed HexiBase's "HexiBox" Tectonic Microspeaker so the wires come out of the side (bottom back when using the stand) instead of the front. This slot in the side is designed to be used with the spring terminal linked below. I also shrunk the x-axis by 6mm so it fits on the Lulzbot Mini's bed, and increased the z-axis by 1mm to be sanded off to ensure no gaps and better adhesion when glued or snapped together. Additionally, I designed a stand so they can be used as desktop speakers and adds space so the wire can be routed behind them.

I also included a control box that houses the amplifier if you want to use the same one I did.

This is designed to be printed without supports and all screw holes are 3mm. The tolerance is very tight between the tongue and groove parts so you may need a clamp to snap them together the first time. Because of this, I found that epoxy wasn't necessary to bond the parts together.

Make sure to sand the tongue and groove until they are flat and lev