Desktop Offset Clock - AMS Required

Inspired by a watch I used to own many (many) years ago in my youth… takes a little while to get used to the offset of the hands but when you nail it the joy is watching other peoples confusion over trying to tell the time with it. I also have a 200mm wall mounted clock based on the same design available here:https://makerworld.com/en/models/1084642-offset-clock-kit-011 Designed around the Bambu Labs clock kit-011 the clock unit simply clips into the back with no need to use the securing nuts. The clock has a built in stand ready for you to display on your desk…. The hour and minute hands are designed to push fit onto the clock spindle but the sizing is based on the kit I received at the time of designing and I am aware that the movements have been known to vary… if the hands are tight then you can trim them with a sharp craft knife (No. 11 blade)… There is a finishing cap that press fits on last to clean up the model… I have not designed a second hand for it at this time but if I do I