Thingiverse
Desktop Usb Holder
von Darthwave
5
Downloads
1
Likes
0
Makes
Desktop organizer with holder for sd / micro-sd card, USB sticks, pens and paper clips.
Contains 2 cavities for inserting two type magnets
Q-19-13-06-N or Parallelepiped type ballast 19.05 x 12.7 x 6.35 mm, pausing during printing at layer 38 (if layer height = 0.2mm).
If you do not want to ballast or insert a magnet, it will suffice to activate the supports (everywhere and 80% cantilever angle).
Typical settings with magnets / ballast:
Layer: 0.2,
Walls: 3,
speed: 60mm / s
Infill: 10% octahedral
Without supports.
Typical settings without magnets / ballast:
Layer: 0.2,
Walls: 3,
Speed: 60mm / s
Infill: 10% octahedral
Supports everywhere in line or zig zag, density: 10%, 80° cantilever angle.
Contains 2 cavities for inserting two type magnets
Q-19-13-06-N or Parallelepiped type ballast 19.05 x 12.7 x 6.35 mm, pausing during printing at layer 38 (if layer height = 0.2mm).
If you do not want to ballast or insert a magnet, it will suffice to activate the supports (everywhere and 80% cantilever angle).
Typical settings with magnets / ballast:
Layer: 0.2,
Walls: 3,
speed: 60mm / s
Infill: 10% octahedral
Without supports.
Typical settings without magnets / ballast:
Layer: 0.2,
Walls: 3,
Speed: 60mm / s
Infill: 10% octahedral
Supports everywhere in line or zig zag, density: 10%, 80° cantilever angle.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
