Thingiverse
Detergent box snout
by rakoivun
1
Downloads
1
Likes
0
Makes
I needed to pour detergent powder to smaller container. It was difficult.
Created this spout to make it easier. Confirmation - it is easier.
Is the snout pretty? Well no. Does it work? Yes.
Detergent box width about 76mm, wall thikness1mm. No supports needed. Print time ~40min.
PLA, 0.35 layer, Prusa Mk2
Created this spout to make it easier. Confirmation - it is easier.
Is the snout pretty? Well no. Does it work? Yes.
Detergent box width about 76mm, wall thikness1mm. No supports needed. Print time ~40min.
PLA, 0.35 layer, Prusa Mk2
rakoivun also publishes on
48 additional models across 1 more platforms
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
