Deus 2 Remote Case

This is an alternate case design for the Deus 2 remote. It consists of a mounting plate with small supports to hold the remote in place. A cover is attached to the plate using studs and thumb nuts. If desired, a sun shield can be attached to the cover with glue or double-sided tape to reduce glare on the remote’s screen.

The supports are printed as separate items and then glued to the plate. The left hand and right hand plates angle the remote's display approximately 15 degrees toward the user's face. The straight plate aligns with the Deus shaft. There are also two styles of plates.....a solid plate and an open back plate. The open back plate saves a little weight and is the best choice for use with the remote's speaker.

M3 x 10 mm long screws are glued into the cover to act as studs. The cover is secured with M3 thumb nuts. This method was chosen for simplicity over the use of M3 threaded inserts.

The remote fits on the center support as shown in one of the photos.