Device Holder Factory

Fully customizable holder for cuboid-shaped handheld electronic devices like smartphones, GPS devices, various handheld sensor devices etc.. The holder can then be mounted with its cylindrical (or rather, octagonal) part to a round clamp of configurable size.

The initial parameter settings make this a holder for the Voltcraft PL-125-T2USB and PL-125-T4USB thermometers. (Mounted with a 2 mm foam layer on three sides to secure it. The next print would have inner width and depth reduced by 1.5 mm.)


## **Parameters**

The main configurable parameters are:

* device width, depth and play in the holder
* holder wall thickness
* connector wall thickness
* holder height
* holder cutout width and depth (to reach the buttons and ports of the device)
* diameter and width of the clamped part, and distance to the holder

Some parameters are interdependent, so they have to be adapted in a certain order. This could be fixed in a future version. For now, follow the instructions in t