Thingiverse
Devli horns (vase mode)
por BrainZapp
78
Descargas
69
Likes
0
Makes
Adjusted some faces to make the model more uniform for vase mode printing.
Cura stil gives me the warning it is not manifold, But it actually is.
Picture in the preview is scaled down to 50mm height, I printed them at 150mm too.
As long as your line width can handle it you can scale these pretty big.
Up until around half way up the model you can go pretty fast (around 100mm/s or faster) just make sure you go to around 50mm/s for the last part or the print will get ruined.
Cura stil gives me the warning it is not manifold, But it actually is.
Picture in the preview is scaled down to 50mm height, I printed them at 150mm too.
As long as your line width can handle it you can scale these pretty big.
Up until around half way up the model you can go pretty fast (around 100mm/s or faster) just make sure you go to around 50mm/s for the last part or the print will get ruined.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
