DeWalt Battery Holder

Thank you to Ben Newboult (crealitycloud.com/user-profile/8303860827?visitorPage=1), who uploaded the design this is slightly modified from.Using Hyper PLA the holders were printed on an Ender 3 V3 KE, and G-code was created using UltiMaker **** 5.8.1 (sorry Creality :( I like the simplicity of the **** program) on standard quality, speed: 200 mm/s, temp: 225, bed: 65, adhesion: raft, and zig-zag supports (to prevent warping).The batteries would not seat properly in the original design, so I used TinkerCAD, to shave 1mm off the underside of the left and right rails (see image). I also made the gap, where the battery lock goes into, 1mm wider on each side. Since these are going into the shop at home, I didn't feel a need to make them look pretty.