DeWalt Blower DCE100 - Pipe holder

DescriptionTool holder that supports the pipe part of the DeWalt DCE100 blower. I printed 3x 56mm rings and 1x 39mm ring in order to hold the pipe (2x rings per section). The 39mm ring has a 9mm step in order to level the pipe to compensate for the decreasing diameter towards the tip. Each part has 2 screw holes and it was designed to fit on a 2"x3" width. NotesPrint 2x 56mm brackets for the larger pipe section.Print 1x 56mm bracket and 1x 39mm bracket for the smaller pipe section.Printed using PLA.FeaturesCan be mounted on any surface that has minimum of 2"x3" space.InstructionsPrint all 4 brackets and line them up properly before screwing them.Make sure you put each bracket on the pipe section just before the diameter gets larger (see pictures). That way, it'll hold the pipe in place.Use 2 screws per bracket. ConsiderationsUse flat head screws for flush installation.I mounted the brackets under a shelf at a 45 degrees angle. The pipe holds great. Boost MeLike my d