Thingiverse
Dewalt String Trimmer Winder
door ucancallmebob89
17
Downloads
9
Likes
0
Makes
This is a tool to help reload string in a Dewalt DCST920 string trimmer. It may be compatible with other trimmers as well.
This device has a 3/8" square socket that can be attached to a socket wrench or a drill/impact driver with a compatible socket driving bit.
When using this device, thread the string into the tool so that you have an even length on either side. Then insert the prongs into the 4 holes and run your drill at a relatively slow speed. Try not to use sudden jerky accelerations, it is plastic after all!
Print at at least 30% infill for strength.
This device has a 3/8" square socket that can be attached to a socket wrench or a drill/impact driver with a compatible socket driving bit.
When using this device, thread the string into the tool so that you have an even length on either side. Then insert the prongs into the 4 holes and run your drill at a relatively slow speed. Try not to use sudden jerky accelerations, it is plastic after all!
Print at at least 30% infill for strength.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
