Dewalt Tstak 'Table top' / connector brackets

Set of designs to make a table top or connector for on top of a DeWalt Tstak toolbox. I used one to create a connector to hold my Ryobi Vacuum on top using https://www.printables.com/model/1044158-ryobi-link-wall-mount-single-cleat as shown in the photos.I have printed in PLA+ and it seems to be holding up well (was initially as a prototype but has been working fine so haven't reprinted in PETG yet but would advise PETG for strength)You will need to print 2 brackets that the tstak clips will grip onto as a minimum.Have included designs for feet that fit into the recesses on the top of the toolbox to help lock it in place and a spacer so thinner board is supported in the middle if necessary.You will need to supply a board to use as the top - MDF or Plywood works well. NB - My photos show my Mk1 version and designs have now been updated, moving the screw positions on the brackets slightly and adding 2 screw holes to the feet to prevent spinning. Assembly InstructionsItems to Print2 x