Thingiverse
DF95 to US1M conversion kit
door willnewton
17
Downloads
13
Likes
0
Makes
This is a base level conversion kit to make your DragonFlight 95 into a class legal US1M. This boat conversion is sometimes known as the Dragonstein. https://www.rcgroups.com/forums/showthread.php?2964063-DragonStein-DF95-to-US1M-conversion
The main part needed is the tailpiece. It extends the hull length to meet the class minimum. I have been calling mine the “stinger”.
The second part extends the keel fin. When used with the stock DF95 ballast bulb, it extends the full depth to just under the class minimum. It is optional and not required to be class legal, but you should use it!
-These min. and max. measurements are based on US1M 2017 class rules.
There are FDM and SLA versions of each part.
US1MstingerFDM.stl - The FDM tailpiece was my original design. It is bulkier than the other version, but prints well on a filament printer. It will print directly on the bed with no supports needed.
US1MstingerSLA.stl - The SLA tailpiece is my 2nd version. It is ligh
The main part needed is the tailpiece. It extends the hull length to meet the class minimum. I have been calling mine the “stinger”.
The second part extends the keel fin. When used with the stock DF95 ballast bulb, it extends the full depth to just under the class minimum. It is optional and not required to be class legal, but you should use it!
-These min. and max. measurements are based on US1M 2017 class rules.
There are FDM and SLA versions of each part.
US1MstingerFDM.stl - The FDM tailpiece was my original design. It is bulkier than the other version, but prints well on a filament printer. It will print directly on the bed with no supports needed.
US1MstingerSLA.stl - The SLA tailpiece is my 2nd version. It is ligh
willnewton publiceert ook op
127 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
