Slicer Discord
dfPlayer Bracket – 3D-Druckmodell von Thingiverse Thingiverse

dfPlayer Bracket

von bobtidey
51 Downloads
29 Likes
0 Makes
Zum Modell
The dfPlayer is a nice audio module that plays back mp3 files stored on a micro SD card. It is very cheap and gives a good basis for turning spare speakers into music playback devices.

The module contains the SD card socket, the audio playback electronics, stereo headphone outputs, and a mono speaker amplifier. It can be controlled either by local buttons or by commands over a serial interface. I use the module in conjunction with a esp8266 processor to give browser based control. https://github.com/roberttidey/dfPlayer

The module can be tricky to mount as one wants to have access to the SD card slot.

This bracket is designed to make that easier by allowing it to be screwed inot a flat panel. A slot for the SD card needs to be cut out of the panel but then the bracket can be secured with 2 screws to securely hold the dfPlayer in place.

The bracket has a little cut out to allow for air circulation around the power amplifier and it aso has a rear hole to allow a wire to be fe
Quelle
Thingiverse
Was du zum Drucken brauchst: Mittel Niedrige Konfidenz
Einteilig Hardware nötig
Supports 1/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 1/3
Drucker
FDM / FFF
Dateiformat
STL
Material
PLA, TPU
Nachbearbeitung
Hardware
Software
Cura, PrusaSlicer o. Ä.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen