Thingiverse
DHT-11 Sensor Housing
von EngBuild
27
Downloads
24
Likes
1
Makes
DHT11 temperature and humidity sensor. Case Enclosure Nut and bolt mount on bottom plate and snap-fit top.
**The bridging on the Top cap does not fit the JST connector. Currently i cut the small piece for it to fit. I will upload a new with a modification if there is enough demand for it.
**The bridging on the Top cap does not fit the JST connector. Currently i cut the small piece for it to fit. I will upload a new with a modification if there is enough demand for it.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
