Thingiverse
DHT11-ESP01 case
von enheragu
1
Downloads
1
Likes
0
Makes
This is a remix in FreeCAD from the original linked model. I did not have the connector that was design for the other model, so I removed part of the piece so that Dupont cables could fix instead.
The lid of the model remains unchanged from the original model.
Print settings are the ones from the original model, you can check it [here](https://www.thingiverse.com/thing:5229799).
Note that depending on the color you use, some light might be visible from the outside (obviously some light might bi filtered through the slots too).
Folding the DHT11 sensor might reduce a little bit the heat captured from the rest of the electronics reducing a bit the noise in the sensor.
The lid of the model remains unchanged from the original model.
Print settings are the ones from the original model, you can check it [here](https://www.thingiverse.com/thing:5229799).
Note that depending on the color you use, some light might be visible from the outside (obviously some light might bi filtered through the slots too).
Folding the DHT11 sensor might reduce a little bit the heat captured from the rest of the electronics reducing a bit the noise in the sensor.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
