Thingiverse

DHT22 Smart Thermometer Housing

von Binsky734

2 Downloads

1 Likes

0 Makes

V2 is in the works. It's designed to fit around the USB brick instead of sitting in front of it, and you'll solder together the case instead of using screws. It will also have a lid for using just the DS18B20 thermometer, using just the DHT-22, or using both (the DHT-22 requires calibration for temperature because the board heats it up a bit). I'm also tinkering with a USB pass-through for v3 so you don't tie up a USB port.

This is a housing for a smart thermometer as part of a smart thermostat project. I created one for each room of my house that has an HVAC vent, and imprinted the room name on the bottom to keep track of them. I also included a blank one so you can customize as needed.

Parts List:

* 6x M3x8 screws
* 2x M2.5x5 screws
* [1x Wemos D1 Mini](https://www.amazon.com/dp/B081PX9YFV)
* [1x DHT-22 Temperature/Humidity Sensor](https://www.amazon.com/dp/B0795F19W6)
* [1x USB A Male Plug to DIP Board](https://www.amazon.com/dp/B07W6T9KPJ)
* Soldering Iron

You don

DHT-22 DHT22 ESP8266 humidity humidity sensor smarthome temperature humidity temperature sensor thermometer Thermometer holder thermometer mount WeMos D1 Mini Wemos D1 mini case DHT-22 DHT22 ESP8266 humidity humidity sensor smarthome temperature humidity temperature sensor thermometer Thermometer holder thermometer mount WeMos D1 Mini Wemos D1 mini case

Quelle

Thingiverse

Was du zum Drucken brauchst: Mittel Niedrige Konfidenz

Einteilig Hardware nötig

Supports 1/3

Zusammenbau 0/3

Einstellungen 1/3

Druckbett 0/3

Nachbearbeitung 1/3

Drucker

FDM / FFF

Dateiformat