Diamond Ring Jewelry Box

Diamond Ring jewelry box. I am including two versions of the main part of the box. One where the top diamond box has ring cut outs and one that does not.  All plates were printed 3 walls 48 first layer speed no brim. When printing the main part of the box I used tree supports. You will need long plyers to get the supports out of the drawer openings. I used normal supports on the drawers and normal snug supports on the lid. Make sure you get the supports on either side of the brim of the lid off. I recommend using gyroid infill for strength. The drawers and lid are each on separate plates. Just line up the guide on the bottom of the drawers to the hole in the base to slide them in. Hope you enjoy this model!