Diamond Sharpening Stone Holder

This is a holder that allows me to use these diamond sharpening stones I purchased from Amazon with the sharpening kit that I have. It can also be used just to hold the stone while you sharpen on a bench or in your hand.

Additional Hardware Used:

4: 10mmx2mm Round Magnets
1: M5x.8x30mm Hex Bolt (these ones were from a kit I got at Harbor Freight)
1x M5x.8 Hex Nut
Clamp and guide rod from a Lansky Kit
Super Glue for magnets

Instructions:

1. Print one holder and Knob, I printed the holder at 10% infill and the knob at 50% for added strength
2. Assemble as shown.
1. Press the bolt into the knob first by starting the bolt into the knob and then screwing it into the nut until it presses into the hole.
2. The nut fits into the grove and then is held in place by the bolt.
3. The magnets may require glue to stay in place.
4. Place the stone you want to use in the assembly, then insert the guide rod into the hole. Flip the assembly over so that the stone and rod are flat