Dice Mold D6

The 2 pieces fit together to create a tube that is taped together, make sure the labels are at the bottom and upside down. Lay down 2 pieces of tape overlaping and place die face firmly on it. Put the tube over the die centering it as much as possible, then pull the tape up along the sides of the tube to seal as much as possible. After, you can mix and pour the silicone and put it straight into the pressure pot to get rid of any bubbles. After taking it out and removing it from the tube, cut out your keys and vasaline the top part of the mold including keyholes. Now were doing to lid so instead of where the label is your going to put the mold back in the tube at the opposite end. after putting the mold back in and retaping, your going to mix and pour your silicone again and put the top with the label face down onto the silicone and put it into the pressure pot again. Take it out of pot and take apart carefully not to tear silicone, and your done! Make sure to spray mold release every t