Dice mold Maker

Decided to make a multipart mold maker for making a single dice mold. Tested and works great mine didn’t even leak any mold material.

Step 1: put right and left together and make sure its level on the bottom. Then add the flat keyed part (NOT THE COMPLETELY FLAT ONE). Cover all surfaces of the print that you don’t want to stick in Vaseline (the walls and the keyed bottom piece) I then cleaned the very center of the keyed part to secure the dice to something. Wrap the outside with elastic bands. (Not sure if this is needed but just to be safe)

Step 2: clean dice and secure to the center of keyed part with whatever you choose to use. (I use sculpty 3) Use as little and humanly possible without letting it move around.

Step 3: Pour in the mold material very slowly. I fill mine to almost the top and place in a pressure pot for a few hours.

Step 4: once cured remove elastic bands and split the mold holder in half and remove the bottom keyed part.

Step 5: clean the top surface