Dice Tray and Holder

This should be a fairly simple dice tray and holder to print for most printers which are large enough to print it. The outer edges of the dice tray measure 15.4 cm x 21.4 cm x 5 cm. The built in dice holder should be capable of holding 8 standard sized dice (d4-d20). The points at both ends of the dice holder are sized appropriately to hold 5 mm x 1 mm magnets to keep the lid in place, with a small allotment for printer tolerance. The sides of the lid were also sized down to provide a decent tolerance, just in case.

Please share any prints that you have done and share any comments or improvements that you may have. You are free to use this or build upon this build, future improvements do include a lid for the dice tray. Enjoy!

-Sean

EDIT (3/8/2018): fixed the magnet receivers for the lid, one had previously been drawn too deep and they are now at the same depth.

EDIT (3/9/2018): I finally printed the first prototype, setting everything so that my printer could print as fas