Dicetower for DSA

Hi Folks,
this is a dicetower I designed for the german Pen and Paper DSA.
If you don't want the engravings for the stats, just print the "_without_engraving" file, there's also a "_clean" file in which the top of the tower is just flat.
The dicetower and dicecatcher are printed in two seperate parts and can be snapped together in a matter of seconds.
The tower prints with minimal support (just activate support for the bottom cutout). After the print, snap out the two support beams I put where you throw in the dice.
Dicetower and catcher took 48 hours on my Ultimaker 2.
Enjoy!