Thingiverse
Die Glocke + launch stand+Haunebu
door Matomato
10
Downloads
8
Likes
0
Makes
Die Glocke second edition with launch stand and Haunebu 2 german space craft.
The bell is assembled from four parts.
Print parts and glue them togrther. After you can paint it .
Print 12 pillars and 12 ring parts.
In cura you can also change you ratio for the bell. The bell was design in smaller known version
All print setings are:
Speed: 60m/s
Infil: 20%
Table temp: 60deg
Extruder temp: 205 deg
Nozzle: 0,4mm
The bell is assembled from four parts.
Print parts and glue them togrther. After you can paint it .
Print 12 pillars and 12 ring parts.
In cura you can also change you ratio for the bell. The bell was design in smaller known version
All print setings are:
Speed: 60m/s
Infil: 20%
Table temp: 60deg
Extruder temp: 205 deg
Nozzle: 0,4mm
Matomato publiceert ook op
5 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!