Die-Hard Ornament

I've seen this concept as a cardboard and tinfoil craft before, just thought it might be nice as a 3D-Printed version.

I made it from scratch in TinkerCAD.
https://www.tinkercad.com/things/i5AELgmv15r-die-hard-ornament/

I have included the images to print in both the original size and one resized to 65mm x 38mm to fit.
There is a template to use to cut out the photo, but if you don't have a really sharp knife, just use it to draw a line on the picture and then cut it out with scissors.

There is a "thinner" version that snaps off at the base every time I try to remove it from the plate, so I have made a "repair-base" that you can print to still use a broken one if you want. The "thicker" version prints fine and comes off in one piece if you're gentle.

I print everything with a 0.6 nozzle so the walls are sized to print with that.
If you use a different size you might end up with artifacts on the surface from the slicer placing infill.

I made the hook to print separate