Thingiverse
Diffuser lampshade for LED bulb
by Lune_Design
8
Downloads
29
Likes
0
Makes
Diffuser lampshade for LED bulb. It can be assembled in just a few seconds and is completely interlocking, without glue or screws.
Simple and elegant lens hood Chandelier Lampshade diffuser for LED bulb.
Very simple to print with only 130 gr. of PLA. It prints without supports. I designed two versions for two maximum capacity dimensions of the 3D printer plates. For these versions, however, you need a printer with a 200 x 200 mm plate or for the larger version, a printer with a 300 x 300 mm plate
The diffuser simply rests on the bulb because it is very light.
There are two versions, one HD where the facets are not seen, while in the other version the facets are highlighted and which in my opinion give an interesting aesthetic effect.
If your bulb has a different diameter, you can scale the model directly in the slicer.
Good light to all !! :)
Simple and elegant lens hood Chandelier Lampshade diffuser for LED bulb.
Very simple to print with only 130 gr. of PLA. It prints without supports. I designed two versions for two maximum capacity dimensions of the 3D printer plates. For these versions, however, you need a printer with a 200 x 200 mm plate or for the larger version, a printer with a 300 x 300 mm plate
The diffuser simply rests on the bulb because it is very light.
There are two versions, one HD where the facets are not seen, while in the other version the facets are highlighted and which in my opinion give an interesting aesthetic effect.
If your bulb has a different diameter, you can scale the model directly in the slicer.
Good light to all !! :)
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!