Thingiverse
Dig Quad Base Remix
von opelone
3
Downloads
1
Likes
0
Makes
Yes I did take on the task, here are the scaling measurements.
X=151.2153 mm. 2562.08%
Y=60.7813 mm. 2526.08%
Z=29.0499 mm. 2526.08%
When I printed mine I changed Z to 18.4131 mm. or 1601.14% which I like better but you just need to drill out the antenna hole a little bit.
X=151.2153 mm. 2562.08%
Y=60.7813 mm. 2526.08%
Z=29.0499 mm. 2526.08%
When I printed mine I changed Z to 18.4131 mm. or 1601.14% which I like better but you just need to drill out the antenna hole a little bit.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!